Wednesday, May 15, 2013

Fab Academy: Networking and Communications

I had already made the boards for this week when I made my RGB LED board. These also had some of the milling problems described there however. Here is the bridge board:

and the node:

I have managed to program the bridge board and get it working using the Providence tutorial here. Here is the serial output from the board as I type 0 into the monitor:

I am having more trouble with the node however, it returning repeated rc=-1 errors. I have thoroughly checked the board and removed a lot of solder from the chip legs but still get the same issues so am still working on getting the whole network working.

No comments: